Users Guide

• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the port command
parameter.)
source port Enter the keywords source-port then the port number to be matched in the ACL rule
in the ICAP rule
destination-port Enter the keywords destination-port then the port number to be matched in the
ACL rule in the ICAP rule.
source-port-range Enter the keywords Source-port-range then the range of the start port to end port
to be matched in the ACL rule in the ICAP rule.
destination-port-
range
Enter the keywords destination-port-range then the range of the start port to
end port to be matched in the ACL rule in the ICAP rule.
Defaults none
Command Modes REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for the track-id on the S4810, S4820T, S6000, S6000-ON, and Z9000.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
show cam pbr
Display the PBR CAM content.
Syntax
show cam pbr {interface interface | stack—unit slot-number port-set number
[pipeline number]} [summary]
Parameters
interface interface Enter the keyword interface then the name of the interface.
stack–unit
number
Enter the keyword stack-unit then the slot number.
port-set number Enter the keywords port-set then the port-pipe number.
summary Enter the keyword summary to view only the total number of CAM entries.
Policy-based Routing (PBR) 999