Users Guide

bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the portcommand
parameter.)
Defaults None
Command Modes REDIRECT-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>] {ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}[track
<obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask | any |
host ip-address} {destination mask | any | host ip-address} [operator]
command.
996 Policy-based Routing (PBR)