Users Guide
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Enabled, that is sending of routing updates are enabled by default.
Command Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
By default, no interfaces are passive. Routing updates are sent to all interfaces on which the routing protocol is
enabled.
If you disable the sending of routing updates on an interface, the particular address prefix continues to be
advertised to other interfaces, and updates from other routers on that interface continue to be received and
processed.
OSPFv3 for IPv6 routing information is not sent or received through the specified router interface. The specified
interface address appears as a stub network in the OSPFv3 for IPv6 domain.
On configuring suppression using the passive-interface command, the state of the OSPF neighbor does not
change to INIT; instead, the state of the OSPF neighbor changes to DOWN after the dead-timer expires.
redistribute
Redistribute into OSPFv3.
Syntax
redistribute {bgp as number}{connected | static}[metric metric-value | metric-
type type-value] [route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
bgp
as number
Enter the keyword bgp then the autonomous system number.
The range is from 1 to 65535.
connected
Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
metric
metric-
value
Enter the keyword metric then the metric value.
982 Open Shortest Path First (OSPFv2 and OSPFv3)