Users Guide

If you have enabled IPsec authentication in an OSPFv3 area with the area authentication command, you
cannot use the area encryption command in the area at the same time.
The configuration of IPsec encryption on an interface-level takes precedence over an area-level configuration. If
you remove an interface configuration, an area encryption policy that has been configured is applied to the
interface.
To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number
command.
Related
Commands
• ipv6 ospf encryption – configure an IPsec encryption policy on an OSPFv3 interface.
• show crypto ipsec policy – display the configuration of IPsec encryption policies.
clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
Syntax
clear ipv6 ospf [vrf vrf-name] process
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to clear IPv6 routes
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
debug ipv6 ospf bfd
Display debug information and interface types for bidirectional forwarding detection (BFD) on OSPF IPv6 packets.
Syntax
[no] debug ipv6 ospf bfd [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Open Shortest Path First (OSPFv2 and OSPFv3) 969