Users Guide

advertise med voice-signaling
To advertise when voice control packets use a separate network policy than voice data, configure the system.
Syntax
advertise med voice-signaling {vlan-id layer2_priority DSCP_value} | {priority-
tagged number}
To return to the default, use the no advertise med voice-signaling {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged, the Layer 2 priority, and then the DSCP value.
Defaults Unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
• debug lldp interface — debug LLDP.
• show lldp neighbors — display the LLDP neighbors.
Link Layer Discovery Protocol (LLDP) 833