Users Guide

Version Description
9.10(0.0) Introduced on the S3048–ON, S3100 series, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, Z9100–ON, and Z9500.
Usage Information
If you use the mac-address-table disable-learning command without specifying any option, the
system does not learn source MAC addresses from LACP or LLDP BPDUs.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address {multicast vlan vlan-id output—range
interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
multicast Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE: Use this option if you want multicast functionality in an L2 VLAN
without IGMP protocols.
output interface For a unicast MAC address, enter the keyword output then one of the following
interfaces for which traffic is forwarded:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
output-range
interface
For a multicast MAC address, enter the keyword output-range then one of the
following interfaces to indicate a range of ports for which traffic is forwarded:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for output range parameter for S4810 and Z9000.
784 Layer 2