Users Guide

• isis ipv6 metric
• isis metric
• isis network point-to-point
• isis password
• isis priority
• is-type
• log-adjacency-changes
• lsp-gen-interval
• lsp-mtu
• lsp-refresh-interval
• max-area-addresses
• max-lsp-lifetime
• maximum-paths
• metric-style
• multi-topology
• net
• passive-interface
• redistribute
• redistribute bgp
• redistribute ospf
• router isis
• set-overload-bit
• show config
• show isis database
• show isis graceful-restart detail
• show isis hostname
• show isis interface
• show isis neighbors
• show isis protocol
• show isis traffic
• spf-interval
adjacency-check
Verify that the “protocols supported” field of the IS-IS neighbor contains matching values to this router.
Syntax
adjacency-check
To disable adjacency check, use the no adjacency-check command.
Defaults Enabled.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Intermediate System to Intermediate System (IS-IS) 721