Users Guide

Usage Information
This command provides egress port information for a given IP flow. This information is useful in identifying which
interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed
packed only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information when load-balance mac
hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
Dell# show ip flow interface Gi 2/42 20.1.1.1 100.1.1.2 protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Gi 2/42
Egress Interface: Gi 2/43
Dell#
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a stack-unit interface, enter the keyword stack-unit then the stack unit
number.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface number.
The range is from 1 to 16383.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces with
non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
668 IPv4 Routing