Users Guide
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
You can specify a weight for an IPv4 or IPv6 static route. If the weight value of a path is 0, then that path is not
used for forwarding when weighted ECMP is in effect. Also, if a path corresponding to a static route (destination)
has a non-zero weight assigned to it and other paths do not have any weight configured, then regular ECMP is
used for forwarding.
You can specify the weight value only to destination address and not on the egress port.
A route is considered for weighted ECMP calculations only if each paths corresponding to that route is configured
with a weight.
You cannot use the VRF attribute of this command to configure routes in a management VRF. When a specific
VRF is deleted, all the configured static routes corresponding to that VRF are automatically removed.
Example
Dell(conf)# ip route 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)# ip route 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)# do show running-config | grep route ip route 1.1.1.0/24 4.4.4.2
weight 100 ip route 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)# ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)# ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#
Dell(conf)# do show running-config | grep route ip route vrf test
1.1.1.0/24 4.4.4.2 weight 100 ip route vrf test 1.1.1.0/24 6.6.6.2 weight
200
Related
Commands
• show ip route — view the switch routing table.
ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
654 IPv4 Routing