Users Guide

Parameters
name Enter one domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
You can only configure one domain name with the ip domain-name command. To configure more than one
domain name, configure the ip domain-list command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
Related
Commands
• ip domain-list — configure additional names.
ip helper-address
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the DHCP server is not on the same
subnet as the client.
Syntax
ip helper-address ip-address
To remove a DHCP server address, use the no ip helper-address command.
Parameters
ip-address Enter an IP address in dotted decimal format (A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
IPv4 Routing 643