Users Guide

Dell#
User Information The following describes the show interfaces port-channel brief command shown in the following
example.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 — for Layer 3
• L2 — for Layer 2
Status Displays the status of the port channel.
• down — if the port channel is disabled (shutdown)
• up — if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
• In Layer 2 port channels, an * (asterisk) indicates which interface is the primary port
of the port channel. The primary port sends out interface PDU.
• In Layer 3 port channels, the primary port is not indicated.
Example
Dell# show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/1 (Up) *
Gi 3/2 (Down)
Gi 3/3 (Up)
Dell#
Related
Commands
• show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address {vlan
vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port channel
to display flow information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
incoming-
interface interface
Enter the keywords incoming-interface then the interface type and the interface
information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
source-ip address Enter the keywords source-ip then the IP source address in IP address format.
Interfaces 611