Users Guide

shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief] [description]
Parameters
channel-number For a Port Channel interface, enter the keyword port-channel then a number. The
range is from 1 to 128.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• For port-channel interfaces, you can specify multiple ports as port-
range. For example, if you want to display information corresponding to
all ports between 1 and 4, specify the port range as show interfaces
port-channel 1 - 4.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number, the
state of the port channel, and the number of interfaces in the port channel.
description (OPTIONAL) Displays the port-channel information with description.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series. Modified to display the LAG failover group status.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following describes the show interfaces port-channel command shown in the following example.
Interfaces 609