Users Guide

SFP 1 Temperature High Alarm Flag = False
SFP 1 Voltage High Alarm Flag = False
SFP 1 Tx Bias High Alarm Flag = False
SFP 1 Tx Power High Alarm Flag = False
SFP 1 Rx Power High Alarm Flag = False
SFP 1 Temperature Low Alarm Flag = False
SFP 1 Voltage Low Alarm Flag = False
SFP 1 Tx Bias Low Alarm Flag = False
SFP 1 Tx Power Low Alarm Flag = False
SFP 1 Rx Power Low Alarm Flag = True
===================================
!-------output truncated -------------------------
Related
Commands
• interface — configure a physical interface on the switch.
• show ip interface — display Layer 3 information about the interfaces.
• show interfaces — display information on a specific physical interface or virtual interface.
• show inventory (S-Series and Z-Series) — display the switch type, components (including media), Dell
Networking OS version including hardware identification numbers and configured protocols.
show interfaces vlan
Display VLAN statistics.
Syntax
show interfaces vlan {vlan-id} [LINE] {description}
Parameters
vlan-id Enter the interface VLAN number. The range is from 1 to 4094.
LINE (OPTIONAL) Enter the name of the VLAN.
description Displays the VLAN interface information with description.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z-Series.
Usage Information
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1 - 4.
Example
Dell# show interfaces vlan 10
Vlan 10 is up, line protocol is down
Address is 90:b1:1c:f4:99:ce, Current address is 90:b1:1c:f4:99:ce
Interface index is 1107787786
Internet address is not set
Mode of IPv4 Address Assignment: NONE
DHCP Client-ID: 90b11cf499ce
592 Interfaces