Users Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added the nfsmount:<mount-point> parameters that
allow you to mount a remote NFS file system.
9.4(0.0) Added the compressed-config parameter.
9.3(0.1) Added the http parameter on the S6000, Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added usbflash and rpm0usbflash commands on E-Series.
7.6.1.0 Introduced on the S-Series and added the SSH port number to the SCP prompt sequence
on all systems.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Dell Networking OS supports a maximum of 100 files at the root directory level on both the internal and external
flash.
When copying a file to a remote location (for example, using Secure Copy [SCP]), enter only the keywords and
Dell Networking OS prompts you for the rest of the information. For example, when using SCP, you can enter
copy running-config scp: where running-config is the source and the target is specified in the
ensuing prompts. Dell Networking OS prompts you to enter any required information for the named destination —
remote destination, destination filename, user ID, password, and so forth.
When you use the copy running-config startup-config command to copy the running configuration
(the startup configuration file amended by any configuration changes made since the system was started) to the
startup configuration file, Dell Networking OS creates a backup file on the internal flash of the startup
configuration.
Dell Networking OS supports copying the running-configuration to a TFTP server, an FTP server, or a remote NFS
file system. For example:
• copy running-config tftp:
• copy running-config ftp:
• copy running-config nfsmount://<mount-point>/filepath
You can compress the running configuration by grouping all the VLANs and the physical interfaces with the same
property. You can store the operating configuration to the startup config in Compressed mode and perform an
image downgrade without any configuration loss.
Example
Dell#copy running-config scp:
Address or name of remote host []: 192.168.1.1
Port number of the server [22]: 22
Destination file name [startup-config]:
User name to login remote host: username
Password to login remote host:
!
4080 bytes successfully copied
Dell#
File Management 55