Users Guide
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis based
on the group address and source address that you specify in the access list, use this feature.
ip igmp immediate-leave
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave command.
Parameters
group-list
prefix-
list-name
Enter the keywords group-list then a string up to 16 characters long of the prefix-list-
name.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information Querier normally sends some group-specific queries when a leave message is received for a group prior to
deleting a group from the membership database. There may be situations when you require immediate deletion of
a group from the membership database. This command provides a way to achieve the immediate deletion. In
addition, this command provides a way to enable immediate-leave processing for specified groups.
ip igmp last-member-query-interval
Change the last member query interval, which is the Max Response Time inserted into Group-Specific Queries sent in response to Leave
Group messages. This interval is also the interval between Group-Specific Query messages.
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, use the no ip igmp last-member-query-interval command.
526 Internet Group Management Protocol (IGMP)