Users Guide

Version Description
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prefix paths with weights in the HW/CAM
on the fly.
If disabled, the CLI would inform the FIB to re-program the destination prefix paths with no weights or regular
ECMP.
Example
Dell(conf)# ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)# ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)# no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)# no ip ecmp weighted
Dell(conf)# do show running-config | grep ecmp
link-bundle-monitor enable
Provides a mechanism to enable monitoring of traffic distribution on an ECMP link bundle.
Syntax
link-bundle-monitor enable
To exit from ECMP group mode, use the exit command.
Command Modes
• ECMP-GROUP
• PORT-CHANNEL INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on an ECMP link bundle.
Syntax
link-bundle-distribution trigger-threshold [percent]
Equal Cost Multi-Path (ECMP) 485