Users Guide

l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol tunnelling. The
range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC ACL.
The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL. The
range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for nlbcluster
ACL. The range is from 0 to 2. By default, the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 2. The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to configure 256 entries. Select 2 to configure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of
NLB entries, Dell Networking recommends that you use a maximum of 64
NLB ARP entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS. The
range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN dual
QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.
Openflow number Enter the keyword openflow and then the number of FP blocks for open flow (multiples
of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number l2pt
number ipmacacl
number ecfmacl
number
{nlbclusteracl]
[vman-qos |
vman-dual-qos
number ] ipv4pbr
number openflow
{4|8} | fcoe
number
[iscsioptacl
number ] [vrfv4acl
number ]
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the
14 entries reserved for internal functionality)
The fcoe range is 0–6 groups. Each group has 128 entries; the value given must be an
even number. This information is stored in the NVRAM and is effective after rebooting
the switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
412 Content Addressable Memory (CAM)