Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

401

402

403

404

405

406

407

408

409

410

ipv4-neighbor-

addr

ipv6-

neighbor-addr

Clear and reapply policies for a neighbor.

peer-group

name

Clear and reapply policies for all BGP routers in the specified peer group.

ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.

in Reapply only inbound policies.

NOTE: If you enter soft, without an in or out option, both inbound and

outbound policies are reset.

out Reapply only outbound policies.

NOTE: If you enter soft, without an in or out option, both inbound and

outbound policies are reset.

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

8.3.19.0 Introduced on the S4820T.

8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.

7.8.1.0 Introduced on the S4810.

7.7.1.0 Introduced on the C-Series.

7.2.1.0 Introduced on the E-Series.

debug ip bgp ipv6 unicast soft-reconfiguration

Enable soft-reconfiguration debugging for IPv6 unicast routes.

Syntax

debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast soft-

reconfiguration

To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-group-

name] ipv6 unicast soft-reconfiguration command.

Parameters

ipv4-address

ipv6-address

Enter the IP address of the neighbor on which you want to enable soft-reconfiguration

debugging.

peer-group-name

Enter the name of the peer group on which you want to enable soft-reconfiguration