Users Guide

Usage Information You can use the both command to migrate from VRRPv2 to VRRPv3. When you set the VRRP protocol version
to both, the switch sends only VRRPv3 advertisements but can receive either VRRPv2 or VRRPv3 packets. To
migrate an IPv4 VRRP group from VRRPv2 to VRRPv3:
1. Set the switches with the lowest priority to both.
2. Set the switch with the highest priority to version 3.
3. Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an extended period of time.
Example
Dell(conf-if-gi-1/1-vrid-100)# version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive both
Dell(conf-if-gi-1/1-vrid-100)# version 3
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group; range is from 1 to 255.
vrf vrf-name (OPTIONAL) Enter the name of a VRF instance to clear the counters of all IPv6 VRRP
groups in the specified VRF. The maximum is 32 characters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to clear the interface configurations corresponding to a range of ports.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Virtual Router Redundancy Protocol (VRRP) 1445