Users Guide

Related
Commands
• ping — tests the connectivity to a device.
undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses both for IPv4 and IPv6
independently.
Syntax
virtual-ip {ipv4-address | ipv6-address}
To return to the default, use the no virtual-ip {ipv4-address | ipv6-address} command.
Parameters
ipv4-address Enter the IP address of the active management interface in a dotted decimal format
(A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Control and Monitoring 139