Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP notification types. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
To configure the router to send SNMP notifications, enter at least one snmp-server host command. If you
enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-
server host command, no notifications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command for each host. You can specify
multiple notification types in the command for each host.
When multiple snmp-server host commands are given for the same host and type of notification (trap or
inform), each succeeding command overwrites the previous command. Only the last snmp-server host
command will be in effect. For example, if you enter an snmp-server host inform command for a host and
then enter another snmp-server host inform command for the same host, the second command replaces
the first command.
The snmp-server host command is used with the snmp-server enable command. Use the snmp-
server enable command to specify which SNMP notifications are sent globally. For a host to receive most
notifications, at least one snmp-server enable command and the snmp-server host command for that
host must be enabled.
NOTE: For v1 / v2c trap configuration, if the community-string is not defined using the snmp-
server community command prior to using this command, the default form of the snmp-server
community command automatically is configured with the community-name the same as specified
in the snmp-server host command.
Configuring Informs
To send an inform, use the following steps:
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
4. Enable traps.
5. Configure a host to receive informs.
Related
Commands
• snmp-server enable traps — enables SNMP traps.
• snmp-server community — configures a new community SNMPv1 or SNMPv2c.
snmp-server location
Configure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text Enter an alpha-numeric text string, up to 55 characters long.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
1270 Simple Network Management Protocol (SNMP) and Syslog