Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1241

sflow ingress-enable

Enable sFlow ingress on interfaces.

Syntax

sflow ingress-enable

To disable sFlow, use the no sflow ingress enable command.

Defaults Disabled.

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S-Series, Z-Series, and MXL switch.

9.2(1.0) Introduced on the Z9500.

Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.

NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG

port.

Commands

• sflow enable (Global) — turn sFlow globally.

sflow extended-switch enable

Enable packing information on a switch only.

Syntax

sflow extended-switch enable

To disable packing information, use the no sflow extended-switch [enable] command.

Parameters

enable Enter the keyword enable to enable global extended information.