Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1101

Parameters

always (OPTIONAL) Enter the keyword always to enable the switch software to always

advertise the default route.

metric

metric-

value

(OPTIONAL) Enter the keyword metric then a number as the metric value. The range is

from 1 to 16. The default is 1.

route-map

map-

name

(OPTIONAL) Enter the keywords route-map then the name of a configured route-map.

Defaults Disabled. Metric: 1.

Command Modes ROUTER RIP

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

Usage Information The default route must be present in the switch routing table for the default-information originate

command to take effect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use this command with the

redistribute command.

Syntax

default-metric number

To return the default metric to the original values, use the no default-metric command.

Parameters

number

Specify a number. The range is from 1 to 16. The default is 1.

Defaults 1