Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

1101

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.5(0.1) Introduced on the Z9500.

9.7(0.0) Introduced on the S6000-ON.

9.5.0.0 Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Usage Information A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the traffic.

The system uses this information use to handle the traffic on the interface based on the traffic priority and places

it into the appropriate shaping queue. You cannot delete a DSCP color map when it is configured on an interface.

If you do, all the DSCP values are set to green (low drop precedence). To delete the DSCP color map that is being

used by one or more interfaces, remove the DSCP map from each interface.

Example

Dell(conf)#qos dscp-color-map mymap

Commands

• qos dscp-color-map— associates the DSCP color map profile with an interface so that all IP packets received

on it is given a color based on that color map.

• dscp— sets the number of specific DSCP values for color map profile to yellow or red.

qos dscp-color-policy

Associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color map.

Syntax

dscp-color-policy color-map-profile-name

To remove a color policy map profile, use the no dscp-color-policy color-map-profile-name

command.

Parameters

color-map-profile-

name

Enter the color map profile name. The name can have a maximum of 32 characters.

Defaults None

Command Modes CONFIG-INTERFACE