Users Guide

Version Description
8.2.1.0 Available on the C-Series and S-Series.
7.5.1.0 Added support for the DSCP Marking option.
7.4.1.0 Introduced on the E-Series.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria.
Related
Commands
• class-map — identifies the class map.
match mac vlan
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
number Enter the VLAN ID. The range is from 1 to 4094.
Defaults none
Command Modes CLASS-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced.
Usage Information To access this command, enter the class-map command. You can match against only one VLAN ID.
Related
Commands
• class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy map (output)
applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name command.
1078 Quality of Service (QoS)