Users Guide

Usage Information Advertise the Extended Power via MDI on all ports that are connected to an 802.3af powered, LLDP-MED
endpoint device.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
Example
Dell(conf)#int gigabitethernet 1/1
Dell(conf-if-gi-1/1)#protocol lldp
Dell(conf-if-gi-1/1-lldp)#advertise med power-via-mdi
Dell(conf-if-gi-1/1-lldp)#show config
!
protocol lldp
advertise med power-via-mdi
Dell(conf-if-gi-1/1-lldp)#
power budget global-threshold
If the switch has an external power supply, this command allows the external power supply of the specified stack member to be used for
powering PoE ports. Use this command to set a global threshold limit for the PoE power budget on a specified stack unit.
Syntax
power budget global-threshold stack-unit stack-unit—number threshold-value
Parameters
stack-unit stack-
unit-number
Enter the keyword stack-unit and the stack unit number. Range is from 1 to 12.
threshold-value
Enter the power threshold limit value in percentage. Range is from 10 to 99. Default value
is 99.
Default None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Increased the stacking range to 12 units in S3100 series.
9.8(2.0) Introduced on the S3100 series.
Usage Information
Configure a global threshold limit for the Power over Ethernet (PoE) power budget for a specified stack unit. A
default power threshold value of 99% is configured when there is no threshold value configured.
Example
Dell(conf)#power budget global-threshold stack-unit 1 10
Dell(conf)#exit
Dell#show power detail stack-unit 1
Unit Total System Redundancy Inline Inline Inline Inline Inline
Power Power Power Power Power Power Power Power
Available Consumed Consumed Threshold Available Allocated Consumed Remaining
(Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts) (Watts)
----------------------------------------------------------------------------------------
1 1100 150 0 10 95 0 0 95
Dell#
power inline
Use this command to enable inline power and configure maximum power allocation with priority for the powered device connected to an
interface.
Syntax
power inline {[max_milliwatts ]| priority {critical | high | low}}
To disable a device that has been enabled for PoE power supply, use the no power inline command.
1030 Power over Ethernet (PoE)