Concept Guide

Congure the following parameters for the virtual terminal lines:
• number: the range is from zero (0) to 8.
• end-number: the range is from 1 to 8.
You can congure multiple virtual terminals at one time by entering a number and an end-number.
2 Congure a level and set the maximum number of messages to print.
LINE mode
logging synchronous [level severity-level | all] [limit]
Congure the following optional parameters:
• level severity-level: the range is from 0 to 7. The default is 2. Use the all keyword to include all messages.
• limit: the range is from 20 to 300. The default is 20.
To view the logging synchronous conguration, use the show config command in LINE mode.
Enabling Timestamp on Syslog Messages
By default, syslog messages include a time/date stamp, taken from the datetime, stating when the error or message was created.
To enable timestamp, use the following command.
• Add timestamp to syslog messages.
CONFIGURATION mode
service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone] [utc] | uptime]
Specify the following optional parameters:
– datetime: To view the timestamp in system local time that includes the local time zone.
– localtime: You can add the keyword localtime to view timestamp in system local time that includes the local time zone.
– show-timezone: Enter the keyword to include the time zone information in the timestamp.
– msec: Enter the keyword msec to include milliseconds in the timestamp.
– uptime: To view time since last boot.
– utc: Enter the keyword utc to view timestamp in UTC time that excludes the local time zone.
If you do not specify a parameter, Dell EMC Networking OS congures datetime as localtime by default.
To view the conguration, use the show running-config logging command in EXEC privilege mode.
To disable time stamping on syslog messages, use the no service timestamps [log | debug] command.
Example 1: Default conguration service timestamps log datetime or service timestamps log datetime
localtime
DellEMC(conf)#service timestamps log datetime
DellEMC#show clock
15:42:42.804 IST Fri May 17 2019
DellEMC#show command-history
[May 17 15:38:55]: CMD-(CLI):[service timestamps log datetime]by default from console
[May 17 15:41:40]: CMD-(CLI):[write memory]by default from console
- Repeated 1 time.
[May 17 15:41:45]: CMD-(CLI):[interface gigabitethernet 1/1]by default from console
[May 17 15:41:47]: CMD-(CLI):[shutdown]by default from console
[May 17 15:41:50]: CMD-(CLI):[no shutdown]by default from console
[May 17 15:42:42]: CMD-(CLI):[show clock]by default from console
[May 17 15:42:52]: CMD-(CLI):[write memory]by default from console
80
Management