Deployment Guide

99
Creates a new OpenFlow controller connection object with the user specified name. The specified name
can be any alphanumeric string up to 64 characters. Use 'no openflow controller <name>' to remove the
specified controller.
Note that this will create a new controller object instance in the running config which can be seen either
by using the show running-config or the show openflow config CLI commands, as shown below.
Example
FJ6K0Z1_console> set openflow controller name test2
Controller test2 (index 0) created
From show openflow config:
OpenFlow Configuration
----------------------
DNOS-OF Version : 1.1
OpenFlow Protocol Version : OpenFlow 1.3.4
System Model ID : N3024P
System Serial Number : CN0C3M5M282984CN0208A02
System MAC Address : f8:b1:56:69:dd:1b
Table Processing Mode : Single Table
Connection Echo Interval (seconds) : 3
Connection Reset Echo Count : 3
OpenFlow Datapath ID : 0x0000000000000181
OpenFlow Datapath Description : DNOS-OF 1.1: N3024P(4TBK0Z1)
OpenFlow Control Network Primary : 192.168.0.10/24
OpenFlow Control Network Backup : 192.168.0.10/24
PID : 965
Failure Mode : SECURE
Flow Misses : CONTROLLER
Flow Tables Synopsis
--------------------
Ingress Flow Table (0)
Current Number of Flows: 0
Max Number of Flows: 2000
VLAN Flow Table (10)
Current Number of Flows: 0
Max Number of Flows: 12288
Termination MAC Flow Table (20)
Current Number of Flows: 0
Max Number of Flows: 512
Unicast Routing Flow Table (30)
Current Number of Flows: 0
Max Number of Flows: 40960
Multicast Routing Flow Table (40)
Current Number of Flows: 0
Max Number of Flows: 8191
Bridging Flow Table (50)
Current Number of Flows: 0
Max Number of Flows: 32767
ACL/Policy Flow Table (60)
Current Number of Flows: 2
Max Number of Flows: 7680
OpenFlow SDN Controllers
------------------------
Controller 0 (name:test2)
Primary : (not configured)