Deployment Guide

set logging component command

Use this API to set the runtime logging components on the switch until rebooted. Use the “set default

logging …” command to store the setting into the system flash running-configuration

Example

FJ6K0Z1_console> set logging

set logging <subcommand>

possible subcommands:

component set component for logging

level

FJ6K0Z1_console> set logging component

set logging component command: valid components are 0-5

FJ6K0Z1_console> help set logging component

set logging component <component>

Set component for logging where component is:

0 = NONE

1 = API

2 = MAPPING

3 = OFDB

4 = DATAPATH

5 = ALL

set logging level command

Use this API to set the runtime logging level for the switch until rebooted. Use the “set default logging …”

command to store the setting into the system flash running-configuration

Example

FJ6K0Z1_console> set logging level

set logging level <level>

Set the logging level. Values above 3 should probably not be turned on for

serial port backed IO like screen consoles/maintenance ports.

The level can be:

0 = OFF (FATAL only)

1 = BASIC (FATAL,ERROR,WARNING)

2 = INFO (FATAL,ERROR,WARNING,INFO)

3 = MESSAGE (FATAL,ERROR,WARNING,INFO,MESSAGEs)

4 = VERBOSE (and then some)

5 = TRACING

6 = ALMOST ALL (except for in progress debugging)

7 = ALL

set dscp-trust command

This command enables the DSCP to egress queue mapping for a packet.

Example

FJ6K0Z1_console> set dscp-trust <port>

Set dscp-trust for a port

FJ6K0Z1_console> set dscp-trust 2