Deployment Guide

64
5.5 Verifying the Switch to Controller Communications
Once the firmware is installed, the management access is configured, and the controller access is configured,
you can verify the status of the controller connection. This is done using the following command:
show openflow config
Example use and expected output is shown below:
FJ6K0Z1_console> show openflow config
OpenFlow Configuration
----------------------
DNOS-OF Version : 1.1
OpenFlow Protocol Version : OpenFlow 1.3.4
System Model ID : N3024P
System Serial Number : CN0C3M5M282984CE0129A02
System MAC Address : f8:b1:56:67:99:91
Table Processing Mode : Single Table
HA features : Enabled
Connection Retry Interval (seconds) : 5
Connection Max Retries : 3
Connection Echo Interval (seconds) : 3
Connection Echo Timeout (seconds) : 5
Connection Reset Echo Count : 3
Connection Failover Delay Time : 4
Connection Failover Delay Time : 17
OpenFlow Datapath ID : 160088049758712
OpenFlow Datapath Description : DNOS-OF 1.1: N3024P(FJ6K0Z1)
OpenFlow Control Network Primary : 192.168.0.55/24
OpenFlow Control Network Backup : 192.168.1.55/24
PID : 965
Failure Mode : SECURE
Flow Misses : CONTROLLER
Flow Tables Synopsis
--------------------
Ingress Flow Table (0)
Current Number of Flows: 0
Max Number of Flows: 2000
VLAN Flow Table (10)
Current Number of Flows: 0
Max Number of Flows: 12288
Termination MAC Flow Table (20)
Current Number of Flows: 0
Max Number of Flows: 512
Unicast Routing Flow Table (30)
Current Number of Flows: 0
Max Number of Flows: 40960
Multicast Routing Flow Table (40)
Current Number of Flows: 0
Max Number of Flows: 8191
Bridging Flow Table (50)
Current Number of Flows: 0
Max Number of Flows: 32767
ACL/Policy Flow Table (60)
Current Number of Flows: 5
Max Number of Flows: 7680
OpenFlow SDN Controllers
------------------------
Controller 0 (name:nec)
Primary : 192.168.0.3:6633
Backup : 192.168.1.3:6633
Priority : 0
Connection Type : TCP
Indigo Role : Master
Connection State: CONNECTED (HANDSHAKE_COMPLETE)