Deployment Guide

146
To verify the flow that was indeed added to the switch, the show openflow flows command can be used
as shown below:
FJ6K0Z1_console> show openflow flows
Showing openflow flow entries for all tables
Ingress Port Table (0) Flow Entries
----------------------------------
Number of entries reported = 0
Maximum number of entries for this table = 2000
Number of entries actually found = 0
VLAN Table (10) Flow Entries
--------------------------------------
Number of entries reported = 0
Maximum number of entries for this table = 12288
| Flow ID:0x9c157cc8 Priority:0 Hard_time:0 Idle_time:0 Cookie:3 inPort:mask = 0:0xffff0000
srcMac:mask = 0000.0000.0000:0000.0000.0000 destMac:mask = 0000.0000.0000:0000.0000.0000 etherType =
0000 vlanId:mask = 100:0xfff srcIp4 = 0.0.0.0/0.0.0.0 dstIp4 = 0.0.0.0/0.0.0.0 srcIp6 = ::/:: dstIp6
= ::/:: DSCP = 0 VRF = 0 DEI = 0 ECN = 0 IP Protocol = 0x00 Source L4 Port = 0 Destination L4 Port =
0 ICMP Type = 0 ICMP Code = 0 | Set CoS queue = 6 outPort = 0
Number of entries actually found = 0
Termination MAC Table (20) Flow Entries
----------------------------------------
Number of entries reported = 0
Maximum number of entries for this table = 512
Number of entries actually found = 0
Unicast Routing Table (30) Flow Entries
----------------------------------------
Number of entries reported = 0
Maximum number of entries for this table = 40960
Number of entries actually found = 0
Multicast Routing Table (40) Flow Entries
-----------------------------------------
Number of entries reported = 0
Maximum number of entries for this table = 8191
Number of entries actually found = 0