Deployment Guide

107
set power reset command
Use the set power reset command to reset the PoE power on a given port. This is useful for ports that are
stuck in an error state.
Example
FJ6K0Z1_console> set power reset <port to reset>
FJ6K0Z1_console> set power reset 1
PoE power on port 1 reset
set power threshold command
Use the set power threshold command to set the power point at which ports are disconnected from PoE.
Example
FJ6K0Z1_console> set power threshold <power level>
FJ6K0Z1_console> set power threshold 29
power threshold set to 29
set vlan-gate enable command
Use the set vlan-gate enable command to enable the vlan gate with pre-set configs on the specified port.
Example
FJ6K0Z1_console> set vlan-gate enable
Set vlan-gate enable <port>
Set vlan gate for a port
FJ6K0Z1_console> set vlan-gate enable 1
set vlan-gate mode command
Use the set vlan-gate mode command to create a vlan gate config with a mode on a specified port.
Example
FJ6K0Z1_console> set vlan-gate mode
Set vlan-gate mode <port> <trubk/access>
Set vlan-gate mode for a port : trunk/access
FJ6K0Z1_console> set vlan-gate mode 1 trunk
Setting VLAN Gate Mode trunk for port 5
set vlan-gate native-vlan command
Use the set vlan-gate native-vlan command to set native-vlan for a port with vlan gate mode in trunk.
Example
FJ6K0Z1_console> set vlan-gate native-vlan
Set vlan-gate native-vlan <port> <vlan_id>
Set native-vlan for a port
FJ6K0Z1_console> set vlan-gate native-vlan 1 10
Setting native VLAN ID 10 for port 5
set vlan-gate port command
Use the set vlan-gate port command to add a vlan id to the associated vlan id list of the specified port’s
vlan gate configuration.