Deployment Guide

PROVIDES EventOFPMeterConfigStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPPortStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPAggregateStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPQueueStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPDescStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPMeterStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPGroupStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPPortStatus TO {'dpset': set(['main'])}

PROVIDES EventOFPMeterFeaturesStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPSwitchFeatures TO {'dpset': set(['config']), 'RestStatsApi': set(['main'])}

PROVIDES EventOFPGroupFeaturesStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPStateChange TO {'dpset': set(['main', 'dead'])}

PROVIDES EventOFPFlowStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPPortDescStatsReply TO {'RestStatsApi': set(['main'])}

PROVIDES EventOFPGroupDescStatsReply TO {'RestStatsApi': set(['main'])}

CONSUMES EventOFPErrorMsg

CONSUMES EventOFPHello

CONSUMES EventOFPEchoRequest

CONSUMES EventOFPSwitchFeatures

CONSUMES EventOFPPortDescStatsReply

BRICK RestStatsApi

CONSUMES EventOFPMeterConfigStatsReply

CONSUMES EventOFPPortStatsReply

CONSUMES EventOFPAggregateStatsReply

CONSUMES EventOFPQueueStatsReply

CONSUMES EventOFPStatsReply

CONSUMES EventOFPDescStatsReply

CONSUMES EventOFPMeterStatsReply

CONSUMES EventOFPGroupStatsReply

CONSUMES EventOFPSwitchFeatures

CONSUMES EventOFPMeterFeaturesStatsReply

CONSUMES EventOFPGroupFeaturesStatsReply

CONSUMES EventOFPFlowStatsReply

CONSUMES EventOFPPortDescStatsReply

CONSUMES EventOFPGroupDescStatsReply

In my example, the IP address of the Ryu controller is 172.25.11.93 and the IP address of the DNOS-OF

switch we were hooking to it is 172.25.161.222

You can log into the instance of the Ryu controller if desired to see it is up and running by SSH to IP using

username: ryu and password: ryu.

Point the DNOS-OF switch to connect to the Ryu controller, you should see something like the

following on the switch console:

ZYX123_console> set openflow controller 172.25.11.93 6633

07-13 21:38:59.311044 of-switch: MSG: src/of-switch/OF_SDNAgent.cpp:SetOpenFlowController:Adding

controller 172.25.11.93:6633, (TCP connection), to configuration