Deployment Guide

70
set ip ssh server
Use to enable the ssh server on the management port and store that state to the switch configuration.
Examples
FJ6K0Z1_console> set ip ssh ?
set ip ssh <subcommand>
possible subcommands:
server enable the ssh server on the management port
set ip syslog service
Use to enable the syslog service on the management port and store that state to the switch configuration.
Examples
FJ6K0Z1_console> set ip syslog service ?
set ip syslog service <ip address> <port>
Set the address and port for remote syslog from the management port. The port
is optional and will default to 514.
set ip telnet server
Used to enable the telnet service on the management port and store that state to the switch
configuration.
Examples
FJ6K0Z1_console> set ip telnet server
set ip telnet server
Enable the IP telnet server on the management port.
set logging subcommand
Use to enable the telnet service on the management port and store that state to the switch configuration.
Examples
FJ6K0Z1_console> set logging
set logging <subcommand>
possible subcommands:
component set component for logging
level
set logging component
Use this API to set the runtime logging components on the switch until rebooted. Use the “set default
logging …” command to store the setting into the system flash running-donfiguration
Examples
FJ6K0Z1_console> set logging
set logging <subcommand>
possible subcommands:
component set component for logging
level
FJ6K0Z1_console> set logging component
set logging component command: valid components are 0-5
FJ6K0Z1_console> help set logging component
set logging component <component>
Set component for logging where component is:
0 = NONE
1 = API
2 = MAPPING
3 = OFDB
4 = DATAPATH
5 = ALL