Deployment Guide

66
reload shutdown and restart the system
set configure system settings
show show system information
system change system settings
unmount unmount usb device
write save configuration to local storage
mount top level command
Displays the available subcommands for the mount command.
Examples
JFTP0Z1_console> mount
mount <subcommand>
possible subcommands:
usb mount usb drive
mount usb
Use the mount usb command to mount the usb file system.
Examples
mount usb
no top level command
Displays the available subcommands for the no command.
Examples
JFTP0Z1_console# no
no <subcommand>
possible subcommands:
ip clear system ip settings
openflow clear system openflow settings
password remove the password for remote ssessions
no ip subcommand
no ip shows what available subcommands are below that.
Examples
JFTP0Z1_console# no ip
no ip <subcommand>
possible subcommands:
address
dhcp disable the management port dhcp client
gateway remove the default gateway from the management port
ssh clear system ip ssh settings
syslog clear system ip syslog settings
telnet clear system ip telnet settings
no ip address
no ip address removes the static IP address from the management interface.
Examples
JFTP0Z1_console# no ip address
no ip address
Delete ip address from management interface
no ip dhcp
This command shuts down the DHCP client on the switch and disables it in the running configuration.
Use the set ip dhcp command to enable it.
Examples
FJ6K0Z1_console> no ip dhcp
no ip dhcp
Disable the management port dhcp client.