Deployment Guide

51
5.5 Verifying the Switch to Controller Communications
Once the firmware is installed, the management access is configured, and the controller access is configured,
you can verify the status of the controller connection. This is done using the following command:
show openflow config
Example use and expected output is shown below:
FJ6K0Z1_console> show openflow config
OpenFlow Configuration
----------------------
System Model ID : N3024P
System Serial Number : CN0C3M5M282984CE0129A02
System MAC Address : f8:b1:56:67:99:91
OpenFlow Protocol Version : 1.3.4
OpenFlow Protocol Connection Type : TCP
OpenFlow Datapath ID : 160088049758712
OpenFlow Datapath Description : DNOS-OF: N3024P(FJ6K0Z1)
OpenFlow SDN Controller Connection Retry Interval : 2000
OpenFlow SDN Controller Connection Max Retries : 0
PID : 971
Failure Mode : SECURE
Flow Misses : CONTROLLER
Flow Tables Synopsis
--------------------
Ingress Flow Table (0)
Current Number of Flows: 0
Max Number of Flows: 2000
VLAN Flow Table (10)
Current Number of Flows: 0
Termination MAC Flow Table (20)
Current Number of Flows: 0
Max Number of Flows: 512
Unicast Routing Flow Table (30)
Current Number of Flows: 0
Max Number of Flows: 40960
Multicast Routing Flow Table (40)
Current Number of Flows: 0
Max Number of Flows: 8191
Bridging Flow Table (50)
Current Number of Flows: 0
Max Number of Flows: 32767
ACL/Policy Flow Table (60)
Current Number of Flows: 0
Max Number of Flows: 7680
SDN Controllers
---------------
Controller Role IP address: IP Port Status
------------------------------------------------------
0 Master 198.18.3.114: 6633 HANDSHAKE_COMPLETE, CONNECTED