Quick Reference Guide

DHCPv6 Commands 971
Example
The following example shows the output from this command when the
device has leased an IPv6 address from the DHCPv6 server on interface 1/0/1.
NOTE: Note that the interface is in client mode.
console#show ipv6 dhcp interface vlan 2
IPv6 Interface................................. Vl2
Mode........................................... Client
State.......................................... ACTIVE
Server DUID....................................
00:03:00:01:00:13:c4:db:6c:00
T1 Time........................................ 0 days 12 hrs 0 mins 0 secs
T2 Time........................................ 0 days 19 hrs 12 mins 0 secs
Interface IAID................................. 20
Leased Address................................. 2017::309D:161:4EF1:DBB1/128
Preferred Lifetime............................. 1 days 0 hrs 0 mins 0 secs
Valid Lifetime................................. 2 days 0 hrs 0 mins 0 secs
Renew Time..................................... 0 days 11 hrs 55 mins 28 secs
Expiry Time.................................... 1 days 23 hrs 55 mins 28 secs
console#show ipv6 dhcp interface vlan 10
T2 Time The T2 (in seconds) time as indicated by the DHCPv6 Server.
T2 value indicates the time interval after which the Client
sends Rebind message to the Server in case there are no replies
to the Renew messages.
Interface IAID An identifier for an identity association chosen by this Client.
Leased Address The IPv6 address leased by the DHCPv6 Server for this
interface.
Preferred Lifetime The preferred life time (in seconds) of the IPv6 Address leased
by the DHCPv6 Server.
Valid Lifetime The valid life time (in seconds) of the IPv6 Address leased by
the DHCPv6 Server.
Renew Time The time remaining (in seconds) to send a DHCPv6 Renew
request to DHCPv6 Server for the leased address.
Expiry Time The time (in seconds) when the DHCPv6 leased address
expires.
Term Description
2CSNXXX_SWUM200.book Page 971 Tuesday, December 10, 2013 1:22 PM