Quick Reference Guide

970 DHCPv6 Commands
show ipv6 dhcp interface (Privileged EXEC)
Use the show ipv6 dhcp interface command in Privileged EXEC mode to
display configuration and status information about an IPv6 DHCP interface
or all interfaces.
Syntax
show ipv6 dhcp interface [ interface-id ]{statistics}
• interface-id —Any valid IP interface. See Interface Naming Conventions
for interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Term Description
Mode Displays whether the specified interface is in Client, Relay, or
Server mode.
State State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
S er ve r D UI D DH C Pv 6 U ni q ue Id e nt if i er of th e D HC P v6 S er v er on th i s
interface.
T1 Time The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
2CSNXXX_SWUM200.book Page 970 Tuesday, December 10, 2013 1:22 PM