Quick Reference Guide

948 DHCP Server and Relay Agent Commands
Syntax
network network-number [ mask | prefix-length ]
• network-number —A valid IPv4 address
•mask— A valid IPv4 network mask with contiguous left-aligned bits.
•
prefix-length —An integer indicating the number of leftmost bits in the
network-number to use as a prefix for allocating cells.
Default Configuration
This command has no default configuration.
Command Mode
IP DHCP Pool Configuration mode
next-server
Use the next-server command in DHCP Pool Configuration mode to set the
IPv4 address of the TFTP server to be used during auto-install. Use the no
form of the command to remove the next server configuration.
Syntax
next-server ip-address
no next-server
• ip-address —The IPv4 address of the TFTP server to use during auto-
configuration.
Default Configuration
There is no default IPv4 next server configured.
Command Mode
DHCP Pool Configuration mode
2CSNXXX_SWUM200.book Page 948 Tuesday, December 10, 2013 1:22 PM