Quick Reference Guide

ARP Commands 929
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The ip proxy-arp command is not available in interface range mode.
Example
The following example enables proxy arp for VLAN 15.
(config)#interface vlan 15
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged EXEC mode to display all entries in
the Address Resolution Protocol (ARP) cache. The displayed results are not
the total ARP entries. To view the total ARP entries, the operator should view
the show ARP results.
Syntax
show arp [brief]
• brief — Display ARP parameters.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC and Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
The show arp command will display static (user-configured) ARP entries
regardless of whether they are reachable over an interface or not.
Example
The following example shows show arp command output.
2CSNXXX_SWUM200.book Page 929 Tuesday, December 10, 2013 1:22 PM