Quick Reference Guide

Priority Flow Control Commands 913
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example #1
console#clear priority-flow-control statistics tengigabitethernet 1/0/1
Example #2
console#clear priority-flow-control statistics
show interfaces priority-flow-control
Use the show interfaces priority-flow-control command in Privileged EXEC
mode to display the global or interface priority flow control status and
statistics.
Syntax
show interfaces interface-id priority-flow-control
• interface-id —A valid Ethernet port identifier.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
NOTE: This command is only available on N40xx series switches.
This command has no user guidelines.
Examples
The following examples show the priority flow control status and statistics.
s1#show interfaces tengigabitethernet 1/0/1 priority-flow-control
Interface Detail:te1/0/1
PFC Configured State: Disabled
PFC Operational State: Enabled
Configured Drop Priorities: 2-7
2CSNXXX_SWUM200.book Page 913 Tuesday, December 10, 2013 1:22 PM