Quick Reference Guide

856 802.1x Commands
• seconds — Number of seconds between re-authentication attempts.
(Range: 300–4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of seconds between re-authentication
attempts to 300.
console(config)# interface gigabitethernet 1/0/16
console(config-if-Gi1/0/16)# dot1x timeout re-authperiod 300
dot1x timeout server-timeout
Use the dot1x timeout server-timeout command in Interface Configuration
mode to set the time that the switch waits for a response from the
authentication server. To return to the default setting, use the no form of this
command.
Syntax
dot1x timeout server-timeout seconds
no dot1x timeout server-timeout
• seconds — Time in seconds that the switch waits for a response from the
authentication server. (Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
2CSNXXX_SWUM200.book Page 856 Tuesday, December 10, 2013 1:22 PM