Quick Reference Guide

846 802.1x Commands
dot1x initialize
This command begins the initialization sequence on the specified port. This
command is only valid if the control mode for the specified port is auto or
mac-based. If the control mode is not auto or mac-based, an error will be
returned.
Syntax
dot1x initialize [interface interface-id]
• interface-id —The port to be initialized.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
dot1x eapolflood
This command enables the flooding of received IEEE 802.1x frames in the
VLAN.
Syntax
dot1x eapolflood
Default Configuration
By default, the switch does not forward received IEEE 802.1x frames, even if
802.1x is not enabled on the switch. This is the default behavior required by
IEEE 802.1x-2010.
Command Mode
Global Configuration mode
2CSNXXX_SWUM200.book Page 846 Tuesday, December 10, 2013 1:22 PM