Quick Reference Guide

VLAN Commands 797
dvlan-tunnel ethertype
Use the dvlan-tunnel ethertype command in Global Configuration mode to
enable the configuration of the inner and outer VLAN tag ethertype.
To configure the EtherType to its default value, use the no form of this
command.
Syntax
dvlan-tunnel ethertype {802.1Q | vman | custom 1-65535 [ primary-tpid ]}
no dvlan-tunnel ethertype
• 802.1Q —Configures the EtherType as 0x8100 (default).
•
vman —Configures the EtherType as 0x88A8
•
custom —Configures a custom EtherType for the DVLAN tunnel. The
value must be in the range 1-65535.
•
primary-tpid —Globally configures the tag protocol identifier on the outer
VLAN tag on all interfaces. If this parameter is not given, the inner vlan is
configured.
Default Configuration
The default outer tag type (secondary TPID) is 802.1Q. The default inner tag
type (primary TPID) is 802.1Q.
protocol vlan group
all
switchport access
vlan
vlan association
mac
show vlan private-vlan –
–
switchport general
forbidden vlan
––
Private VLAN Commands
switchport private-
vlan
private-vlan show interfaces
switchport
show vlan private-vlan
switchport mode
private-vlan
–––
2CSNXXX_SWUM200.book Page 797 Tuesday, December 10, 2013 1:22 PM