Quick Reference Guide

RADIUS Commands 705
console(config-radius)#auth-port 2412
deadtime
Use the deadtime command in Radius mode to configure the minimum
amount of time to wait before attempting to recontact an unresponsive
RADIUS server. If a RADIUS server is currently active and responsive, that
server will be used until it no longer responds. RADIUS servers whose
deadtime interval has not expired are skipped when searching for a new
RADIUS server to contact.
Syntax
deadtime deadtime
• deadtime — The amount of time that the unavailable server is skipped
over. (Range: 0-2000 minutes)
Default Configuration
The default deadtime interval is 0 minutes.
Command Mode
Radius mode
User Guidelines
If only one RADIUS server is configured, it is recommended to use a
deadtime interval of 0.
Example
The following example specifies a deadtime interval of 60 minutes.
console(config)#radius-server host 192.143.120.123
console(config-radius)#deadtime 60
debug aaa accounting
Use the debug aaa accounting command in Privileged EXEC mode to enable
debugging for accounting.
Use the no form of the command to disable accounting debugging.
2CSNXXX_SWUM200.book Page 705 Tuesday, December 10, 2013 1:22 PM