Quick Reference Guide

RADIUS Commands 701
aaa accounting dot1x default start-stop
The aaa accounting network default start-stop group radius command has
been migrated to the aaa accounting dot1x default start-stop {radius|none}
command. Use the aaa accounting dot1x default start-stop command in
Global Configuration mode to create an accounting method list.
Use the no form of the command to delete a list. A list may be identified by
the default keyword or a user-specified listname.
Use either the aaa accounting dot1x default none or no aaa accounting
dot1x default command to disable dot1x accounting.
Syntax
aaa accounting dot1x default start-stop {radius|none }
no aaa accounting dot1x default
aaa accounting dot1x default none
aaa accounting {exec|commands} {
listname |default} {none|start-
stop|stop-only} {radius|tacacs|radius tacacs|tacacs radius}
no aaa accounting {exec|commands} {default|list}
• commands —Perform accounting on all user executed commands
(TACACS only).
•
exec —Perform accounting on EXEC terminal sessions.
•
listname —The name of an Accounting Method List. The list name can
consist of any printable character. Use quotes around the list name if
embedded blanks are contained in the list name.
•
none —Disable issuing accounting notices for the specified list.
Default Configuration
IEEE 802.1x accounting is not enabled by default.
Command Mode
Global Configuration mode
2CSNXXX_SWUM200.book Page 701 Tuesday, December 10, 2013 1:22 PM