Quick Reference Guide

682 QoS Commands
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port | port-
channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
If the interface is specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are
displayed.
The following table lists the parameters in the example and gives a
description of each.
Example
The following example displays the dot1p traffic class mapping and user
priorities.
console#show classofservice dot1p-mapping
User Priority Traffic Class
------------- ---------------
01
Parameter Description
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which
the user priority value is mapped.
2CSNXXX_SWUM200.book Page 682 Tuesday, December 10, 2013 1:22 PM