Quick Reference Guide

QoS Commands 679
• interface — Specifies any valid interface. Interface is Ethernet port or
port-channel (Range: po1-po32 or gi1/0/1-gi1/0/24)
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to redirect incoming packets to port 1/0/1.
console(config-policy-classmap)#redirect 1/0/1
service-policy
Use the service-policy command in either Global Configuration mode (for all
system interfaces) or Interface Configuration mode (for a specific interface)
to attach a policy to an interface. To return to the system default, use the no
form of this command.
Syntax
service-policy {in|out} policymapname
no service-policy {in|out} policymapname
• policymapname —Specifies the DiffServ policy name as a unique case-
sensitive alphanumeric string. (Range: 1–31 alphanumeric characters.)
•
in —Apply the policy on ingress.
•
out —Apply the policy on egress.
Default Configuration
This command has no default configuration.
2CSNXXX_SWUM200.book Page 679 Tuesday, December 10, 2013 1:22 PM