Quick Reference Guide

LLDP Commands 555
Default Value
LLDP-MED is disabled on all supported interfaces.
User Guidelines
No specific guidelines.
Example
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#lldp med
lldp med confignotification
This command is used to enable sending the topology change notification.
Syntax
lldp med confignotification
no lldp med confignotification
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, notifications are disabled on all supported interfaces.
User Guidelines
No specific guidelines.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax
lldp med faststartrepeatcount count
2CSNXXX_SWUM200.book Page 555 Tuesday, December 10, 2013 1:22 PM