Quick Reference Guide

548 Link Dependency Commands
Syntax
depends-on {gigabitethernet | port-channel | tengigabitethernet |
fortygigabitethernet}
intf-list
no depends-on {gigabitethernet | port-channel | tengigabitethernet |
fortygigabitethernet}
intf-list
• intf-list — List of ports in unit/slot/port format or port-channel numbers.
Separate nonconsecutive items with a comma and no spaces. Use a hyphen
to designate the range of ports or port-channel numbers. (Range: Valid
Ethernet interface or port-channel list or range)
Default Configuration
This command has no default configuration.
Command Mode
Link Dependency mode
User Guidelines
Circular dependencies are not allowed, i.e. interfaces added to the group may
not also appear in the depends-on list.
Examples
console(config-linkDep-group-1)#depends-on gigabitethernet 1/0/10
console(config-linkDep-group-1)#depends-on port-channel 6
show link-dependency
Use the show link-dependency command to show the link dependencies
configured for a particular group. If no group is specified, then all the
configured link-dependency groups are displayed.
Syntax
show link-dependency [ group GroupId ] [detail]
• GroupID —Link dependency group identifier. (Range: Valid Group Id,
1–16)
•
detail —Show detailed information about the state of members and the
dependent ports.
2CSNXXX_SWUM200.book Page 548 Tuesday, December 10, 2013 1:22 PM